Pearl and rings jewelry set

This bubbly necklace-and-earrings set reminds me of champagne. Anchored by wrapped loops, the golden pearls float between hammered rings for a shimmering, effervescent look.

Read the instructions below, or download the free project PDF above.

Supplies

Necklace 20 in. (51 cm)

• 11 10 mm crystal pearls
• 4 6 mm crystal pearls
• 4 27 mm hammered rings
• 9 24 mm hammered rings
• 45 in. (1.1 m) 22-gauge half-hard wire
• hammered toggle clasp
• chainnose and roundnose pliers
• diagonal wire cutters

Earrings

• 2 10 mm crystal pearls
• 2 27 mm hammered rings
• 2 24 mm hammered rings
• 6 in. (15 cm) 22-gauge half-hard wire
• pair of earring wires
• chainnose and roundnose pliers
• diagonal wire cutters

Gold rings from Beadalon; visit beadalon.com for retailers. Gold clasp from Artbeads.com, 866.715.2323866.715.2323 FREE.

Instructions – Necklace

2. Use the 10 mm pearl units to attach rings. Complete the wraps as you go.

3. On each end, use two 6 mm pearl units to attach half of a clasp.

Instructions – Earrings

1. Following necklace step 1, make a 10 mm pearl unit, completing the wraps on one loop. Attach a 27 mm ring and a 24 mm ring to the other loop and complete the wraps.

2. Open the loop of an earring wire. Attach the dangle and close the loop. Make a second earring.